CurrentBody LED Mask Timer
CurrentBody LED masks use medical-grade LEDs with a simple 10-minute hands-free protocol.
Disclaimer: All product names, trademarks, and registered trademarks are property of their respective owners. We are not affiliated with, endorsed by, or sponsored by CurrentBody. This page provides independent timing guidance only and does not constitute medical advice.
Always follow manufacturer instructions. See our Terms of Use .
10 minutes
Session
2 (Red + NIR)
Wavelengths
3-5x/week
Frequency
Full face + neck
Coverage
Simple Timing
Set timer to 10:00. No zone tracking needed - mask covers everything.
Light Wavelengths
633nm Red Light
Benefits: Collagen production, anti-aging, fine lines
Reaches dermis layer
830nm Near-Infrared
Benefits: Deep healing, inflammation reduction
Penetrates deepest
Treatment Protocol
- Cleanse face - Remove makeup, clean skin thoroughly
- Apply serum (optional) - LED can enhance product absorption
- Set timer to 10:00 - Standard session length
- Position mask - Secure straps, ensure full coverage
- Close eyes, relax - Timer will alert when done
- Apply moisturizer - Seal in benefits post-treatment
Treatment Schedule
Initial Phase (4-6 weeks)
- 5 times per week
- 10 minutes per session
- Consistent timing daily
Maintenance
- 3-5 times per week
- 10 minutes per session
- Adjust based on results
CurrentBody Products
Face & Neck Mask
Full coverage, flexible silicone, both wavelengths
TriWave+ Eyes
Eye-specific treatment, 3 min sessions
Best Practices
- Use on bare skin or over light serums
- Avoid thick creams under mask
- Keep eyes closed during treatment
- Clean mask with soft cloth after each use
- Store flat to maintain shape
Timer Setup
- Set duration to 10:00 - Standard CurrentBody session
- Enable audio alert - Know when session ends
- Keep screen on (optional) - Track remaining time
- Disable loop - Single session is sufficient
Quick Start
Set timer to 10:00. Clean face, put on mask, close eyes, relax.